Electric Transfer Pump | 15 l/min – 4 gpm | Diesel, Water, Antifreeze.

£84.00 Price ex.Vat

Self-priming electric pumps of small dimensions with bronze gears for transferring of liquids.

Transfer of diesel fuel between tanks, refuelling of tractors and earth moving equipment
– transfer of water
– transfer of light weight lube oils, antifreeze

In stock (can be backordered)

06 - 10 units | Per unit: £75.60
11 - 20 units | Per unit: £71.40
21 - 99 units | Per unit: £67.20

Description

Self-priming electric pump for the transfer of liquids of varied nature. The pumping elements are made up of PTFE gears which can possibly even run dry for brief periods. Completely equipped with in-line filter on the inlet side.
Pump body in nickel-plated brass and stainless steel shaft. Main applications: transfer of diesel fuel, antifreeze, water.

Technical Details

Type: UP3 – 164 000 13
Volt: 24
Fuse: 5A
Flow Rate (*): 15 l/min – 4 gpm
Pressure: 2 bar – 29 psi
Weight: 1.4 Kg – 3.1 lb
Wire size: 0.75 mm2 – 18 AWG
Motor power (W): 120
Protection: IP 67

(*) Internal tube Ø 13 mm
(**) Length up to 2 m

INSTALLATION

It is recommended that the use of the pump be according to normative safety standards.

The pump can be mounted in any position. Fix the pump utilizing suitable diameter screws corresponding to the holes.

To ensure the correct directional flow of the fluid as indicated by the arrow on the top plate, it is necessary to connect the positive pole (+) of the battery supply to the red wire on the motor end-cap and the negative pole (-) to the black wire.

Electrical connections must be made using adequate terminal blocks and connectors ensuring a tight fitment of the electrical cables.
Bad wiring can cause power losses and/or overheating of the cabling itself.

Operation cycle

The pump can operate on a continuous cycle with the following conditions:

– pressures not exceeding 50% of the maximum pressure indicated in the technical
– temperature of the motor below 60/70 °C – 140/158 °F

It is possible to operate at higher pressures/ampere draw if On/Off cycles are used.
This will allow the motor to cool down to the indicated temperatures.
Long pipelines and / or reduced diameters, bottlenecks and dispensing guns, affect the operating pressure (which is not automatically limited): in these cases, check that the pressure and the electrical draw do not exceed the values of the attached diagrams.

Additional information

Weight 1500 g
Dimensions 166 × 101 × 159 mm